![]() ![]() Run regedit to load the offline system hive.ī. To determine whether the offline image has been prepared using Sysprep:Ī. Press ALT+TAB to return to the capture wizard and continue the process.Ĭause 2: The volume does not contain an image that was prepared using Sysprep. Confirm that you have access to the local disk that contains the offline image.ĥ. Press SHIFT+F10 to access a command prompt.Ĥ. To load the driver yourself in Windows PE:Ģ. Create a capture image using this updated boot image. Windows Server 2008 R2: In the Windows Deployment Services MMC snap-in, right-click the boot image, and click Add Driver Packages to Image.ģ. Windows Server 2008: Mark the image as offline (disabled) and use the tools included in the Windows AIK to insert the necessary drivers to the image. To inject drivers into a boot image, and use the boot image to create a capture image: To do this, use one of the following procedures: To Windows PE so that it can detect the local disk that contains the offline Sysprep image. If it is not, you need to add the driver for your mass-storage controller Ensure that the volume that contains the offline Sysprep image is viewable. Select each disk (for example, sel dis 0 and sel dis 1), and then type lis vol to list each volume. To troubleshoot this, when the Image Capture Wizard first starts, press SHIFT+F10 to open a command prompt. Cause 1: The boot image does not contain the proper drivers for the computer’s hard disk drive controller.There are two common reasons for this problem: ![]()
0 Comments
Leave a Reply. |